Description:
<jats:title>Abstract</jats:title><jats:p>Styrenic polymers and copolymers are often impact modified with rubber particles. The efficiency of rubber toughening depends mainly on the size of the rubber particles and the degree of cross‐linking. The deformation rate, the temperature, the orientation of the polymer molecules and the efficiency of rubber grafting also influence rubber toughening. It is thought that on impact, cavitation inside the rubber particles occurs which reduces the detrimental dilatational stress in the bulk polymer without forming cracks in the brittle matrix or at the rubber‐matrix interface. Crazing and shearing are facilitated if the rubber particles can easily cavitate. This can be achieved by either avoiding too much cross‐linking or by adding oil (silicone oil in the case of ABS) into the rubber particles, which acts as nuclei for void formation. An electron spectroscopic imaging method is described which allows visualizing the location of the oil. Already after cooling silicone oil modified ABS samples down to liquid nitrogen temperature rubber cavitation is observed. This cavitation is caused by the thermal stress developing due to the differences in thermal expansion coefficient between the rubber phase and the SAN‐matrix and is facilitated by silicone oil. Voiding also leads to an increase of light scattering, which can be detected by an optical microscope using dark field illumination.</jats:p>