• Medientyp: E-Artikel
  • Titel: A Study of Low-Potential Heat Utilization Methods for Oxy-Fuel Combustion Power Cycles
  • Beteiligte: Rogalev, Andrey; Rogalev, Nikolay; Kindra, Vladimir; Zlyvko, Olga; Vegera, Andrey
  • Erschienen: MDPI AG, 2021
  • Erschienen in: Energies
  • Sprache: Englisch
  • DOI: 10.3390/en14123364
  • ISSN: 1996-1073
  • Entstehung:
  • Anmerkungen:
  • Beschreibung: <jats:p>The world community is worried about the effects of global warming. A few agreements on the reduction of CO2 emissions have been signed recently. A large part of these emissions is produced by the power production industry. Soon, the requirements for thermal power plant ecology and efficiency performance may become significantly higher. Thus, the contemporary problem is the development of highly efficient power production facilities with low toxic and greenhouse gas emission. An efficient way to reduce CO2 emissions into the atmosphere, which implies maintaining economic growth, is the creation of closed thermodynamic cycles with oxy-fuel combustion. The Allam cycle is one of the most promising among oxy-fuel power plants. A 50 MW pilot Allam cycle plant was built in Texas. The design for a commercial system with an electrical output of 300 MW is under development. This work is devoted to the improvement of the efficiency and environmental safety of oxy-fuel combustion power cycles via the utilization of compressed working fluid heat. The results of computer simulation obtained using AspenONE software demonstrated that an additional circuit in the multi-flow regenerator might increase net efficiency by 3.5%. Besides this, the incorporation of a supercritical carbon dioxide (S–CO2) Brayton cycle with recompression increased the efficiency by 0.2%. Therefore, the maximum net efficiency of the prospective power unit was 51.4%.</jats:p>
  • Zugangsstatus: Freier Zugang