Erschienen in:Journal of Manufacturing and Materials Processing
Sprache:
Englisch
DOI:
10.3390/jmmp8020069
ISSN:
2504-4494
Entstehung:
Anmerkungen:
Beschreibung:
<jats:p>Minimum quantity lubrication (MQL) technologies possess great potential for improving the sustainability of manufacturing processes, which can reduce the absolute quantity of metalworking fluid (MWF) and also enable near-dry chips that are easier to recycle. During drilling in particular, the MWF is transported to the contact zone through internal cooling channels of the drilling tool. The MWF supply and its associated flow behaviour in the transfer from the outlet of the cooling channels to the contact zone have not been sufficiently investigated yet. Great potential is seen in the proper delivery of the MQL into the contact zone. This work aims to visualize and quantify the cooling lubricant supply into the cutting zone using the MQL technique. The visualization of the MQL application is made possible by high-speed shadowgraphic imaging. Detailed image processing is used to evaluate the resulting images. The developed evaluation routine allows for the assessment of the impact of the main process parameters such as the varying pressure of the aerosol generator and the cooling channel diameter. It is found that the oil leaves the cooling channels at the tip of the drill bit in the form of ligaments. An increase in pressure and cooling channel diameter leads to an increase in the frequency of oil ligament separation. Three main flow regimes are identified with different separation frequencies. Low inlet pressures result in intermittently dispersed droplets. The most upper pressure levels lead to an almost continuous dispersion of the oil. At the same time, the air and oil mass flow rates also increase.</jats:p>