• Medientyp: E-Artikel
  • Titel: Properties Evaluation of Thin Microhardened Surface Layer of Tool Steel after Wire EDM
  • Beteiligte: Straka, Ľuboslav; Čorný, Ivan; Piteľ, Ján
  • Erschienen: MDPI AG, 2016
  • Erschienen in: Metals, 6 (2016) 5, Seite 95
  • Sprache: Englisch
  • DOI: 10.3390/met6050095
  • ISSN: 2075-4701
  • Entstehung:
  • Anmerkungen:
  • Beschreibung: This paper describes results of experimental research on the thin microhardened surface layer of a machined surface that occurs in materials using wire electrical discharge machining (WEDM) with brass wire electrode. The direct influence of microhardened surface layer on resulting machined surface quality of tool steel EN X210Cr12 (W.-Nr. 1.2080) was examined. The aim of the experiment was to contribute to the knowledge of mutual interactions between main WEDM technological parameters, the influence of these parameters on the total affected depth, and on the variation of microhardness of sub-surface layers of machined surface. Based on the microhardness experimental measurements, mathematical models were established by the Least Square Method (LSM) in order to simulate and predict final quality of machined surface after WEDM. Recommendations are given for setting the main technological parameters of the discharge process concerning minimization of total microhardened surface layer depth and microhardened surface layer homogeneity along the whole cross-section profile of the machined surface.
  • Zugangsstatus: Freier Zugang